GlampShine Product Directions: Installation Guidelines

On this page, you'll discover installation and recommended usage instructions for GlampShine products. Browse through the page to locate the specific product you're interested in.

 

FADENEW RV RESTORATION COATING DIRECTIONS: 

Shake well before using. Always test FadeNew in an inconspicuous area. Apply FadeNew at 70°F (21°C) or higher. FadeNew works better in direct sunlight and warmer temperatures, the warmer, the better. The surface must be washed, dried, wax-free, and black streaks or stains removed before applying FadeNew. For best results, use our “Buff on” Gray microfiber buffer pads 10” (Larger areas) or 6” Gray microfiber buffer pad (Smaller areas) to apply FadeNew along with hand applicators included for hard-to-reach areas. Use 10” or 6” microfiber buffer pads with a standard orbital buffer only! DO NOT USE a “Rotary” or “DA” polisher. Apply a small to medium amount of FadeNew to the microfiber buffer pad and please note that a little bit can go a long way depending on the level of RV faded oxidized surface. Next press the buffer against the RV surface before turning it on. With medium pressure buff on FadeNew and work the coating onto the RV surface overlapping and covering the oxidized and faded RV surface completely with no heavy coats, one even thin coat is all you need, and “Buff off” excess only with Black 10” or 6” microfiber buffer pads included, do not wipe off with a towel! Allow FadeNew time to cure, depending on temperature and humidity. The warmer the temperature, FadeNew will cure faster and the cooler the temperature will cure slower. Do not apply FadeNew in the rain and avoid contact with water or rain for 24 hours. After completing the application, the microfiber buffer pad is NOT REUSABLE and must be disposed of. DO NOT WASH OR REUSE THE MICROFIBER BUFFER PAD AFTER USE. Extra microfiber buffer pads are included. After use, replace the red plug cap and dispenser cap back on the bottle and store in a cool dry place. FadeNew does cure and dry to open air. Please note Do not place decals over FadeNew, but FadeNew can be put over decals. Any RV wash soap can be used over FadeNew.

 

PRONEW RV CERAMIC COATING DIRECTIONS: 

Shake Well before using. The RV surface must be washed, dried, wax free and black streaks or stains removed before applying PRONEW. For best results apply in a 2’ X 2’ section at a time. Spray PRONEW onto the RV surface and wipe off with a clean microfiber towel. PRONEW RV ceramic coating bonds quickly and produces superior shine results. It is that easy.  Any RV wash products can be used over PRONEW.